ZyXEL Communications Corporation X150N Manual Do Utilizador
Safety Warnings
•
Do NOT use this product near water, for example, in a wet basement or near a
swimming pool.
swimming pool.
•
Do NOT expose your device to dampness, dust or corrosive liquids.
•
Do NOT stack things on the device.
•
Do NOT install, use, or service this device during a thunderstorm. There is a
remote risk of electric shock from lightning.
remote risk of electric shock from lightning.
•
Connect ONLY suitable accessories to the device. Do NOT open the device or unit.
Opening or removing covers can expose you to
Opening or removing covers can expose you to
dangerous high voltage points or
other risks. ONLY qualified service personnel should
service or disassemble this
device. Please contact your vendor for further information.
•
Make sure to connect the cables to the correct ports.
•
Place connecting cables carefully so that no one will step on them or stumble over
them.
them.
•
Always disconnect all cables from this device before servicing or disassembling.
•
Use ONLY an appropriate power adaptor or cord for your device.
•
Do NOT use the device if the power adaptor or cord is damaged as it might cause
electrocution.
electrocution.
•
If the power adaptor or cord is damaged, remove it from the power outlet.
•
Do NOT attempt to repair the power adaptor or cord. Contact your local vendor to
order a new one.
order a new one.
•
Do not use the device outside, and make sure all the connections are indoors.
There is a remote risk of electric shock from lightning.
There is a remote risk of electric shock from lightning.
•
Do NOT obstruct the device ventilation slots, as insufficient airflow may harm your
device.
device.
•
Antenna Warning! This device meets ETSI and FCC certification requirements when
using the included antenna(s). Only use the included antenna(s).
If you mount your device on the wall, please make sure there will be no damage to
electrical wires, gas or water pipes.
using the included antenna(s). Only use the included antenna(s).
If you mount your device on the wall, please make sure there will be no damage to
electrical wires, gas or water pipes.
•
Connect the power adaptor or cord to the right supply voltage (for example 110V
in North America or 230VAC in Europe
in North America or 230VAC in Europe
•
Do NOT allow anything to rest on the power adaptor or cord and do NOT place the
product where anyone can walk on the power adaptor or cord.
product where anyone can walk on the power adaptor or cord.
•
Make sure the cable system is grounded so as to provide some protection against
power surge.