Spectralink Corporation RCH400 Manual Do Utilizador

SpectraLink Corporation 

Installing the Outdoor Base Station 

4.  Installing on a Light Pole or Electrical Pole 

Items provided:  Outdoor enclosure, Base Station 
Items needed: 

4 - “Caddy” or “B-Line” 3/8” Beam Clamps 
2 - EOG 100 or Equivalent Band Clamps 

1.  Attach one band to the top flange of the outdoor enclosure using 2 beam clamps 

(see the figure below). 

2.  Attach the second band to the bottom flange of the enclosure using the 

remaining 2 beam clamps. 

3.  Wrap the band clamps around the pole and tighten using the screw on the band 

clamps. 

See figures in Section 2 for pictorial data for the remaining steps: 
4.  Slide the Base Station cable through the compression fitting and tighten the 

fitting. 

5.  Crimp an RJ45 onto the Base Station cable using the same wiring guide as the 

indoor Base Station. 

6.  Plug the RJ45 into the RJ48C connector. 
7.  Place the Base Station into the enclosure with the side of the Base Station with 

the mounting hole facing the pole.  The Base Station should fit tightly between 
the foam. 

8.  Screw the outdoor enclosure lid back onto the enclosure. 

 PN: 72-0050-00-D.doc 

Page 9