Intercontinental Technologies Ltd F22-24E0032 Manual Do Utilizador
Intercontinental Technologies, Ltd.
Page 4 of 87
Chapter 2
• If the transmitter battery power becomes insufficient, the transmitter will send out an Emergency
Stop signal (EMS). This signal will stop all actions previously set to shut down when a STOP
signal is received. The LED on the transmitter will illuminate red continuously and the buzzer on
the transmitter will buzz continuously until the batteries are removed. If this occurs, replace all
four batteries before using the product again.
signal is received. The LED on the transmitter will illuminate red continuously and the buzzer on
the transmitter will buzz continuously until the batteries are removed. If this occurs, replace all
four batteries before using the product again.
• The magnetic safety key should be removed from the transmitter whenever it is not in use and
should only be issued to authorized personnel.
• All TELECRANE F22 Radio Remote Controls are tested before they leave the factory.
However, they should not be used in dangerous situations or in a manner such that damage might
result.
result.
• Although the transmitter is very durable and weather-resistant, precautions should always be
taken to limit its exposure to weather, physical impact, and corrosives.
• After use, or if the unit will not be used for a long interval, turn off the power to the crane and
remove the magnetic safety key from the transmitter.
• Remove the batteries from the transmitter if the transmitter will not be used for two weeks or
longer.
• Transmitters that are not in use, including spare transmitters, should be secured to prevent
accidental operation.
• Before each shift, check that the limit switches on the crane function correctly.
• Before each shift, check that the movement of the crane corresponds to the button being pressed
on the transmitter.
• Do not use the product during lightning storms or high electrical interference conditions.
2.5 Safety When Performing User Maintenance
Before performing any maintenance on this product, review Chapter 5, “User Maintenance.”