Intercontinental Technologies Ltd F22-24E0032 Manual Do Utilizador
Intercontinental Technologies, Ltd.
Chapter 2
Page 3 of 87
Chapter 2
Safe Operation
Emergency Procedure
In case of emergency, perform these steps IN ORDER:
1. Press the Red STOP Button.
2. Turn the Green Rotary Key Switch to the OFF position and remove the key from
2. Turn the Green Rotary Key Switch to the OFF position and remove the key from
the transmitter.
3. Switch off the main power to the crane.
4. Contact your distributor or installer.
4. Contact your distributor or installer.
NOTE: Read ALL safety information before you operate this
product.
2.1 Emergency
Procedures
If the F22 unit detects an error or system fault, it will issue an emergency STOP command and
deactivate all systems programmed for a STOP command. It is therefore important to install the F22
system correctly so that if it detects a fault, it can perform an emergency stop and the crane will shut
down safely.
deactivate all systems programmed for a STOP command. It is therefore important to install the F22
system correctly so that if it detects a fault, it can perform an emergency stop and the crane will shut
down safely.
2.2 General Safety Information
This manual is intended for the user as a general reference only. Please consult your
distributor for installation or assistance with specific technical issues. In an industrial
environment, safety must always be a top priority. Persons responsible for installation, operation,
and maintenance must make certain that both their actions and the equipment on which they work
are safe. This chapter includes a list of safety rules that must be followed when working with
TELECRANE products, as well as cranes in general. This list is not intended to be all-inclusive.
General industrial safety rules must always be followed. If there is any doubt about how to proceed,
always take the safest course of action.
distributor for installation or assistance with specific technical issues. In an industrial
environment, safety must always be a top priority. Persons responsible for installation, operation,
and maintenance must make certain that both their actions and the equipment on which they work
are safe. This chapter includes a list of safety rules that must be followed when working with
TELECRANE products, as well as cranes in general. This list is not intended to be all-inclusive.
General industrial safety rules must always be followed. If there is any doubt about how to proceed,
always take the safest course of action.
2.3 Installation
Safety
Only qualified personnel should install this product. For installation instructions and safety
information, refer to Part 2 of this manual.
information, refer to Part 2 of this manual.
2.4 Operational
Safety
• Operating any piece of equipment in an industrial facility can be dangerous; therefore, provide
adequate training to operators of cranes that use this equipment.
• At least once each shift, check the amount of power remaining in the transmitter batteries (see
Section 4.1.3, “Checking Battery Power”). If it is low, change all four batteries before beginning
operation. Operating the unit with excessively discharged batteries can be unsafe.
operation. Operating the unit with excessively discharged batteries can be unsafe.