Itron Inc. CCU100T Manual Do Utilizador
Chapter 3 Installing the CCU/Repeater
32
CCU 100 and Repeater 100 Installation Guide
Proprietary and Confidential
Providing Power
The final step of the CCU/Repeater installation is to provide power to the CCU. Depending
on the CCU/Repeater model, either a two pin cable (DC), three pin cable (AC), or a five pin
cable (solar) is required.
on the CCU/Repeater model, either a two pin cable (DC), three pin cable (AC), or a five pin
cable (solar) is required.
Caution Do not move or tilt the CCU for one minute after connecting power.
Moving or tilting a CCU too soon after connecting power may cause it to reset to
the factory image.
Moving or tilting a CCU too soon after connecting power may cause it to reset to
the factory image.
To provide power
1. Plug the appropriate cable in to the CCU/Repeater.
Note The connector is keyed so that the cable can connect in only one orientation.
2. Securely fasten the power cable to the CCU/Repeater by tightening the retaining nut
on the cable.