Garmin AT Inc. SL-70 Manual Do Utilizador

Once the cable assemblies are complete and the connectors are attached to the mounting
frame, install the mounting frame assembly in the aircraft instrument panel. Be sure to use low
profile head screws so the unit will slide in and out freely. Attach the front of the mounting
frame to the instrument panel. Use support brackets to attach the rear of the frame to the
aircraft.

To install the SL70 in the mounting frame, make sure the cam lock is rotated so the rear part
is up, then slide the unit into the frame and tighten with the 3/32 hex tool. The unit will be
pulled into the frame by the cam lock and the connectors will fully engage.

To remove the SL70 from the mounting frame, use the hex tool and turn the tool CCW. The
unit will be pushed out of the frame by the cam lock assembly. No special extraction tools are
required.

The SL70 installation kit includes a 37 pin dsub shell and crimp contacts. The crimp contacts
are specified for 20 to 24 AWG wire. Make the crimp connections with a crimp tool as
specified in the Special Tools Required section on page 4. All wires should be 20 to 24 AWG
unless otherwise specified. Wiring diagrams are included on pages 10 and 11.