CALAMP WIRELESS NETWORKS INC. BDP4-EXT8 Manual Do Utilizador
120 20195-100 Preliminary
Paragon4 – UHF, 700, & 800MHz User Manual
14
3.1.5.1
Power Supply Rear Connections
The rear panel connections are:
• Auxiliary Inputs –
• Auxiliary Inputs –
The DE-9 connector on the T809-10 rear panel provides access to the remote control of the power
supply (reserved for future use).
supply (reserved for future use).
• Output Voltage Adjust –
The output voltage of the power supply can be increased (up to 18V approximately) to compensate
for the voltage drop lost along the cable. Access
the trim-pot through a small hole on the rear panel.
To adjust the output voltage use a trimmer tool
with a Phillips head or 3mm blade (do not use a
standard flat blade screwdriver to make the ad-
justment):
for the voltage drop lost along the cable. Access
the trim-pot through a small hole on the rear panel.
To adjust the output voltage use a trimmer tool
with a Phillips head or 3mm blade (do not use a
standard flat blade screwdriver to make the ad-
justment):
• To increase the output voltage, turn the trim-
pot clockwise.
• To decrease the output voltage, turn the trim-
pot counterclockwise.
pot clockwise.
• To decrease the output voltage, turn the trim-
pot counterclockwise.
If the output voltage is increased on a power sup-
ply operating at, or close to, full load, the power
supply loading must be reduced accordingly or the
module may overheat and shut down.
ply operating at, or close to, full load, the power
supply loading must be reduced accordingly or the
module may overheat and shut down.
• Feedthrough Terminal Block –
The DC Output Terminal block on the rear of the
T809-10 is a Phoenix Contact HDFKV 10. This is
a screw-type terminal connector that uses a cage
mechanism to clamp the conductor(s). See section
2.4.1.1 for recommended torque settings.
T809-10 is a Phoenix Contact HDFKV 10. This is
a screw-type terminal connector that uses a cage
mechanism to clamp the conductor(s). See section
2.4.1.1 for recommended torque settings.
• Protective Bonding Terminal –
• 120 VAC Connector –
Use the supplied 10A-rated IEC type power cord.
Figure 10 - T809 Rear panel (shown upright)
AUXILIARY INPUTS
OUTPUT 13.8 VDC
30A MAX
- +
- +
100-240 VAC 50/60Hz
1
9
Output voltage adjust
Feedthrough terminal
block
13.8 VDC output
Negative (-)
Positive (+)
Protective
bonding
terminal
terminal
Neutral
Live
Earth