ADC Telecommunications Inc. DSR0805A Manual Do Utilizador

ADCP-75-163WB • Issue 1 • August 2004

© 2004, ADC Telecommunications, Inc.

7. Remove dust caps from the optical fiber connectors and the primary optical transceiver.

8. Clean each connector (follow connector supplier’s recommendations) and then insert the

optical fiber connector pair into WBDR PCIx Host card optical FWD/REV port.

9. Place the optical fibers within the cable guides provided on the cable management tray and

then dress and secure the fibers at the WBDR PCIx Host card per standard industry practice.

10. Connect the forward and reverse path optical fibers to the remote (radio head) unit as

specified in the instructions provided with that unit. 

11. Use the designation card provided to indicate the location and name of the remote (radio

head) unit that is connected to the WBDR PCIx Host card. The designation card holder
may be attached to any convenient flat surface.

The modular optical transceivers are available separately and may or may not be installed in the
WBDR PCIx Host Card depending on the configuration ordered. If the optical transceivers are
factory installed in the WBDR PCIx Host Card, skip this section and proceed to 

. If the optical transceivers are not factory installed, use the

following procedure to install each transceiver: 

Note: Leave the dust cap in place on any unused optical transceiver.

Note:  To prevent damage to the remote optical receiver, there must be at least 15dB of
attenuation at the optical receiver port.

19310-A