ADC Telecommunications Inc. PSM230WM Manual Do Utilizador
Page 36
FlexWave Prism Remote Unit RF Module Installation Guide
©2015 TE Connectivity
TECP-77-141 Issue 8 • 300001744178 Rev H • August 2015
Latches on Legacy Dual-Bay 40W RF Modules
For Legacy Dual-Bay 40W RF Modules, secure four latches, as shown in
.
Four latches in a
Legacy Dual-Slot 40W
RF Module
Legacy Dual-Slot 40W
RF Module
Figure 20. Legacy Dual-Bay 40W RF Module Latches
Verify that the RF Module Mounting Hook is Engaged
Verify that the RF Module Mounting Hook is engaged correctly by pulling the module away from the heat sink.
The RF Module should not move. If the RF Module moves during this check, repeat all the steps starting at
The RF Module should not move. If the RF Module moves during this check, repeat all the steps starting at
Connect the RF Module Cables to the PRU Chassis
The steps to connect the RF Module cables have been separated into two different procedures; follow the steps
that correspond to the RF Module being installed.
that correspond to the RF Module being installed.
•
•