ADC Telecommunications Inc. PSM7A7UD Manual Do Utilizador
Install the RF Module(s)
Page 26
FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2013 TE Connectivity Ltd
TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013
Install the RF Module into the Prism Remote Chassis
Recommendation:
Install Dual‐Bay Dual‐Slot modules in the two upper‐most slots of the PRU.
Recommendation:
Install Dual‐Slot 40W modules in the bottom‐most slots of the PRU.
Recommendation:
If both a Dual‐Slot AWS2100 40W RF Module and a Dual‐Slot PCS1900 40W
RF Module are installed in a Quad‐Bay PRU, install the AWS2100 Module in
the lower‐most slot of the PRU.
RF Module are installed in a Quad‐Bay PRU, install the AWS2100 Module in
the lower‐most slot of the PRU.
1
Hold the RF Module so that the DART card(s) face away from the PRU and the Mounting Hook
is toward the Receiving flange on the PRU chassis.
is toward the Receiving flange on the PRU chassis.
NOTE:
Always install RF Modules from the bottom up. Do not skip a slot.
2
Holding the RF Module at a 45° angle in respect to the rear heatsink, rest the bottom surface
of the module on the RF Module shelf, as shown in one of the following graphics, and as
applicable to the RF Module.
of the module on the RF Module shelf, as shown in one of the following graphics, and as
applicable to the RF Module.
•
Single‐Slot RF Module:
•
HDM RF Module:
•
Dual‐Bay Dual‐Slot RF Module:
•
Dual‐Slot 40W RF Module: