MOTREX CO. LTD. AT-E1000P Manual Do Utilizador
RF spec.
- AT-E1000P or AT-E1000P : 5180 – 5220 MHz, 5745 – 5825 MHz
2402 – 2480 MHz
Hardware version
FCC Caution
Class B Digital Device
Note : This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications, However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications in construction of this device which are not expressly
approved by the party responsible for compliance could void the user's authority to
operate the equipment.
Part 15C
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received. Including interference that may
cause undesired operation.
- AT-E1000P or AT-E1000P : 0.7
Software version
- AT-E1000P or AT-E1000P : 1.1.6
Operating Temperature
- AT-E1000P or AT-E1000P : 0-40 Degree C
Power supply
- AT-E1000P or AT-E1000P : 5.0 Vd.c.
- This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
- Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisee aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et.
(2) l'utilisateur de l'appareil doit accepter tout brouillage radio electrique subi, meme si le
brouillage est susceptible d'en compromettre le fonctionnement.
- This equipment should be installed and operated with minimum 20 cm between the radiator
and your body.
- Cet appareil doit être installé et utilisé avec un minimum de 20 cm entre le radiateur et votre
corps.
- This device is restricted to indoor use only within the 5.15 ~ 5.25GHz Band.
- Cet appareil est restreint à l'utilisation à l'intérieur seulement dans la bande 5.15 ~ 5.25GHz.