Cybiotronics Limited 3000 Manual Do Utilizador

100 Montgomery Street., Ste. 1500, San Francisco, CA 94104 •  

415-367-6300

 

contact info: robert weinberg x6359

enter pairing mode

 – Press and hold the 

 and 

 keys simultaneously for 

three seconds until all four mode keys flash red twice and you hear two short 

beeps to confirm you are in programming mode.

enter 

 – Using the numeric keypad on the remote,  

enter 

. The 

 mode key will flash red twice, 

indicating the remote is ready to receive the Home ID. 

enter a new 4-digit Home iD

– Using the numeric keypad, 

enter the 4-digit Home ID you want to program (using “0–9” 

such as 1234). The 

 mode key on the Point Anywhere 

RF Remote Control will flash red twice and you will hear two 

short beeps. At the same time, the blue power LED on the 

USB converter will flash for two seconds, then remain solid 

blue. This indicates that the  Home ID pairing was successful.

 If the pairing process is interrupted or inactive for 

This feature will set the master power control to power on/off all selected devices 

with a single key press. Power Macro can only be assigned to the 

 mode 

key. By default the 

 key will turn the AT&T U-verse Receiver on/off each 

time it is pressed. Once the TV is programmed, the 

 key will turn on both 

the receiver and the TV. You can also set up power control options, which can 

turn the receiver, TV, DVD, and audio device on/off with a single key press. Power 

sequence is determined by the order in which the devices were programmed. 

Use the instructions below only if you want to change the sequence in which 

these devices are powered on and off.

Press the 

mode key.

10

 

Check that the 

 key lights up when you press any button 

on the remote control. If not, check whether the batteries are properly 

seated or if they need to be replaced.

 If one setup method does not work, try another method and you 

may have better results.

 When the battery power is low, the

 key will flash red 

five times with each key press. Note: The remote control cannot be 

programmed when the battery power is low.

 If you’re unable to set up using Auto Search, please see “Program 

your remote control using manual setup” on p. 6 of this guide.

Model: AT&T U-verse Point Anywhere RF Remote Control
IR Range: up to 30'*
RF Range: up to 100'*
* The range quoted is calculated based on an unobstructed line-of-sight test 

under optimum conditions. Actual range will vary depending on conditions 

and can be less than the maximum possible. Your actual range will be 

limited by several factors, including, but not limited to, battery strength, 

electromagnetic interference, infrared interference, and obstructions.

The AT&T U-verse Point Anywhere RF Remote Control is intended and sold 

for use only with AT&T U-verse Receivers. May not be compatible with all 

entertainment systems or capable of accepting every programming code  

for other devices. Limited one-year replacement-only warranty. 

15

On your TV – Press the blue  

 button on the bottom  

of your remote,  then select Remote Control Setup,  

or go to att.com/uverseremote