Cybiotronics Limited 3000 Manual Do Utilizador

100 Montgomery Street., Ste. 1500, San Francisco, CA 94104 •

415-367-6300

contact info: robert weinberg x6359

DTP

UVEP640

Point Anywhere Remote Guide -Spread 12 (p12-13)

Change back to RF control (ACTIVATE RF CONTROl)

If you want to reactivate the RF control, follow the instructions below:

Step 1:

enter pairing mode

– Press and hold the

and

MENU

keys simultaneously for three seconds until all four mode

keys flash red twice and you hear two short beeps to

confirm you are in programming mode.

Step 2:

enter

9 6 9

– Using the numeric keypad on your remote,

enter

9 6 9

. The mode key will flash red twice to confirm it’s

in pairing mode. The

AT&T

mode key on the Point Anywhere

RF Remote Control will flash red and beep twice to confirm

activation of RF control.

NOTE:

If the programming is interrupted or inactive for

more than 10 seconds, the mode key will give a long red

flash and you will hear a long beep. This indicates the Point

Anywhere RF Remote Control has left the programming

mode and returned to normal operation without saving

any changes. You will have to start over again.

Assign volume control for AT&T and DVD modes

By default, the volume controls are automatically assigned to control your TV

unless an audio device is programmed into the remote control, which then sets

the volume keys to control the audio device. The instructions below demonstrate

how the volume controls can be set to control the volume and mute function for

the device of your choice.

NOTE:

This allows you to manually assign volume control to the preferred device.

Step 1:

Press the

AT&T

mode key.

Step 2:

enter pairing mode

– Press and hold the

and

MENU

keys simultaneously for three seconds until all four mode

keys flash red twice and you hear two short beeps to

confirm you are in programming mode.

Step 3:

Press

VOLUME UP

– Press the

VOLUME UP

key. The

AT&T

mode key

will blink red once.

Step 4:

Select the device you wish to use for volume control

–

Press the selected mode key of the device you wish to use

for volume control. The selected mode key will flash red

twice and you will hear two short beeps to indicate the

volume control has been successful assigned.

Reassign Channel Lock to another mode, not AT&T mode key

Step 1:

Press the

AT&T

mode key.

Step 2:

enter pairing mode

– Press and hold the

and

MENU

keys simultaneously for three seconds until all four mode

keys flash red twice and you hear two short beeps to

confirm you are in programming mode.

Step 3:

enter

9 7 3

– Using the numeric keypad on

the remote, enter

9 7 3

. The

AT&T

mode key

will flash red twice.

Step 4:

Press

CHANNEL UP

– Press the

CHANNEL UP

key. The

AT&T

mode key will flash red once.

Step 5:

Select the device you wish to use for channel control

–

Press the selected mode key of the device you wish to use

for channel control. The selected mode key will flash red

twice and you will hear two short beeps to indicate the

channel control is set.