Tait International Limited TBCK4B Manual Do Utilizador
DRAFT 4
36
Operation
TB9400 Installation and Operation Manual
© Tait Electronics Limited September 2011
3.1
Front Panel
The user controls and indicator LEDs on the front panel are shown in
. They allow some manual control over the
base station
and
monitoring of its operational status.
Note
If there is more that one reciter in a subrack, inputs from all recit-
ers are summed to drive the front panel LEDs.
ers are summed to drive the front panel LEDs.
Speaker and
Microphone
Connector
Microphone
Connector
The speaker and microphone connector are not used in this release of the
base station
.
Power LED
The green power LED is lit when power is supplied to the subrack.
Alarm LED
The red alarm LED will flash at a rate of 2 to 5 Hz when an alarm has been
generated by any of the
generated by any of the
base station
modules. It will continue to flash until
the alarm is canceled or the fault is fixed. Note that only those alarms which
are enabled using the
are enabled using the
web interface
will cause this LED to flash.
Figure 3.1
Operating controls on the control panel
b
speaker
f
receive LED
c
microphone connector
g
transmit LED
d
power LED
h
keypad
e
alarm LED
i
display
b
c
d
e
f
g
i
h
b c
d
e
LED
Description
On (steady)
The
base station
is in Offline mode (regardless of the presence of
any fault).
Flashing
The
base station
is in Online mode, and one or more faults are
present.
Off
The
base station
is in Online mode, and no faults are present.