N. V. Nederlandsche Apparatenfabriek NEDAP ADRRFMD Manual Do Utilizador

Page 

 of 

38

59

Manual iSense Lumen series

RFID coaxial cable

If the Ethernet cable is connected, connect the RFID coaxial cable in the same way. Connect from Gate 1 (next)

to Gate 2 (previous), from Gate 2 (next) to Gate 3 (previous), etc.

The RFID coaxial cables should be connected from the NEXT port of one reader, to the PREVIOUS port of the

second reader. PREVIOUS and NEXT are related to the order of units in relation to the first Power Inserter.

Please make sure that you don't make sharp bends in the RFID coaxial cable. This will have a

negative impact on the performance of the system.

Don't use a tool to tighten the RFID coaxial cable connectors. This is not necessary and might break

the connectors. If the connector is tightened by hand, that is good enough.

Status LEDs

The electronics inside the unit has several status LEDs that can be used to discover the status of each part of

the electronics.

Renos unit

1

Green

On

There is a Renos unit connected to the OUT port of this unit

Off

There is 

 Renos unit connected to the OUT port of this unit

no