Axcera 79XITS-7045 Manual Do Utilizador
WaveCom Electronics Inc
MA4040D Manual; MAN1L0901 REV 13(0104)
Approved: D.P.
45
C3.1 MA/UC 4040
From the Menu Selection Bar, click on MA/UC 4040 and select Demo. The following window will open:
C3.1.1 MA/UC 4040 Utility Description
Module Selection
When using this software with the MA4040x or DUAL4040x you will need to select the appropriate slot position of
the Upconverter module that you wish to control. Looking at the FRONT of the MA4002x Chassis, the slot positions
are labeled A though J from left to right and the DUAL4040x will use slots A and B
the Upconverter module that you wish to control. Looking at the FRONT of the MA4002x Chassis, the slot positions
are labeled A though J from left to right and the DUAL4040x will use slots A and B
*
*
When using this software to control the UC4040x, you MUST select slot position A.
The information that is displayed for the module selected reflects the current condition of the Upconverter at the
time that the module is selected. To update this information you must double click the desired module again.
time that the module is selected. To update this information you must double click the desired module again.
Frequency
Frequency (MHz) displays the current center RF output frequency setting. The center RF output frequency may be
adjusted from 53 to 857 MHz in 12.5 kHz step sizes. Click on the Update Frequency button to send the new center
RF frequency setting to the Upconverter.
adjusted from 53 to 857 MHz in 12.5 kHz step sizes. Click on the Update Frequency button to send the new center
RF frequency setting to the Upconverter.
Entering an invalid frequency value will generate a Syntax Error
response.