HP 6000WLAN Manual Do Utilizador

Página de 170
Add-On Devices
Replacing the Hard Disk Drive
94
Reference GuideStartup Guide
Replacing the Hard Disk Drive
To replace the hard disk drive
You’ll need a small Phillips screwdriver for this procedure.
1.  Unplug the AC adapter if you’re using one, and remove the battery.
2.  Turn the unit bottom side up and remove both hard drive screws.
3.  Raise the cover on the end of the drive so that its retainer tab is free of the computer
casing, then gently pull the hard drive out of the computer.
4.  Gently slide the new drive into the hard drive compartment. Press firmly to make sure
the connector seats properly.
5.  Slide the cover down into place (so the retainer tab engages the casing), and reinstall
both hard drive screws.
Important
If you are installing a new hard disk drive, you should create a Utility partition on the
drive before loading any software. See “To recover the factory installation of your hard
disk” on page 129.
To install the holder on a new hard disk drive or prepare a new hard disk for use, see
“Replacing the Hard Disk Drive” in the online Reference Guide.