HP 6000WLAN Manual Do Utilizador

Add-On Devices

Reference GuideStartup Guide

95

To replace the hard disk drive holder

If you are installing a new hard drive that does not have a cover, you can remove the
cover parts from the old hard drive. You’ll need a small Phillips screwdriver for this
procedure.

1.  Remove all four screws from the holder and drive case, then lift the drive out of the

holder.

2.  Notice that the hard drive has a pin connector attachment at one end. Carefully

remove this connector from the end of the drive. Work alternately at each end so that
the connector slides off evenly without bending the connector pins.

3.  Carefully put the pin connector attachment back onto the pins on the end of the new

hard drive. Work alternately at each end so that the connector slides on evenly
without bending the connector pins.

4.  Insert the connector through the end of the holder, and lower the drive into the holder.

5.  Reinstall all six screws into the holder and drive case.

To prepare a new hard disk drive

When you install a new hard disk drive, you also need to prepare it to be able to work
with your computer.