Glenayre Electronics Inc. GL-T8600-CN Manual Do Utilizador

DSP Exciter

Glenayre Document Number: 9110.00172

INSTALLATION AND SETUP

Issue 1, Rev. I: 01/15/97

Page: 4-4

Print Date: 02/19/97

4.5

Setup

Note

When doing a setup for a wideband DSP exciter, the net channel change
time must be set for 300 ms.

Refer to the DSP exciter VDT Menus and user manual for transmitter-control setup infor-
mation. All setup is done via the front-panel VT100 interface.

4.6

Ultimate Disposition

Caution

This equipment may contain hazardous materials.
Check with the local EPA or other environmental
authority before disposing of this equipment.

Table 4-5 Exciter Control Board Jumper Positions

Jumper

pre version 2.10 software

version 2.10 software

JW1

set to A for external 10 MHz oscillator

set to B for internal 10 MHz oscillator

JW2

set to A for password protection

set to B to bypass password protection

JW3

set to A for external VSWR protection

always set to B (for internal and/or ex-
ternal VSWR protection)

set to B for internal VSWR protection