Glenayre Electronics Inc. GL-T8600-CN Manual Do Utilizador

DSP Exciter

Glenayre Document Number: 9110.00172

INSTALLATION AND SETUP

Issue 1, Rev. I: 01/15/97

Page: 4-2

Print Date: 02/19/97

4.4.2

Power Requirement

The DSP exciter, when used as a component of a transmitter, draws its power from system
wiring. Current draw is less than three amperes at 22 to 29 volts. It is normally powered by
the transmitter power supply but can be powered by an auxiliary supply.

4.4.3

Input/Output Connections

Figure 3-3, DSP Exciter Simplified Functional Diagram

, shows the locations of I/O

connectors;

Table 4-2, DSP Exciter I/O Connectors

, lists I/O connectors and describes

their functions. Normally the exciter is delivered as part of an entire transmitter and has
already been installed in a rack, with all connections already made, except for connections
to equipment that was not installed in the rack before shipment. If I/O connections are
required, refer to the system-interconnect diagram and other instructions in the transmitter
manual.

4.4.4

Signal Functions

See

Table 4-2, DSP Exciter I/O Connectors

, which references other tables that describe

pin-by-pin functions of multipin connectors.

Figure 4-1, DSP Exciter/PA Control

Circuit Boards Interconnection Diagram

, shows interconnections among internal

assemblies.

Table 4-2 DSP Exciter I/O Connectors

stencil/connector