Kastle Systems International AIO-W Manual Do Utilizador
To install and use the reader:
Connect the reader wires using wire nuts or beanie wire connectors to the
existing wire run coming out of the mounting hole or receptacle box. Make sure to
connect all wire by color white to white, green to green, black to black, and red to
red.
connect all wire by color white to white, green to green, black to black, and red to
red.
Remove the reader cover to expose the mounting holes. Push wire bundle back
in to mounting hole or receptacle box. Mount the reader to the wall / or door
frame by securing screws through both mounting holes. Replace the front cover
of the reader.
frame by securing screws through both mounting holes. Replace the front cover
of the reader.
Terminate the other end of the wire run with a terminal block as shown below to
the Daughter board TB2.
After the reader is terminated and connected on both ends and power is applied,
the blue LED should turn on and the reader should be ready to use within 0 to 10
minutes (depending on system updates).
minutes (depending on system updates).