ICOM 301500 Manual Do Utilizador

34

4

RECEIVE AND TRANSMIT

D Convenient functions for transmit

• VOX (voice operated transmit) (p. 53)
±  Push 

 to turn the VOX function ON or OFF.

 • 

“

” appears when the VOX function is ON.

±  Push and hold 

 for 1 sec. to enter the VOX 

set mode, then rotate [DIAL] to adjust the VOX 
gain, anti VOX gain or VOX delay.

 • 

Rotate 

[M-CH] to select an item.

• Speech compressor (p. 57)
±  Push 

 to turn the speech compressor ON 

or OFF.

 • 

“

” appears when the speech compressor is ON.

±  Push and hold 

 for 1 sec. to enter the com-

pression level set mode, then rotate [DIAL] to ad-
just the compression level.

D About 5 MHz band operation (USA version only)

Operation on the 5 MHz band is allowed on 5 dis-
crete frequencies and must adhere to the following:
• USB mode
• Maximum of 50 watts ERP 

(Effective Radiated Power)

• 2.8 kHz bandwidth

It is the operator’s responsibility to set all controls so 
that the transmission in this band meets the stringent 
conditions under which we may use these frequen-
cies.

 NOTE: We recommend that you store these fre-
quencies, mode and filter settings into the mem-
ory channel for easy recall.

IC-7200 

Display Frequency*

FCC Channel 

Center Frequency*

5.33050 MHz

5.33200 MHz

5.34650 MHz

5.34800 MHz

5.36650 MHz

5.36800 MHz

5.37150 MHz

5.37300 MHz

5.40350 MHz

5.40500 MHz

* The channel center frequencies that are specified 

by the FCC, show the center frequency of their 
passband. However, the IC-7200 displays carrier 
point frequency, so set 1.5 kHz below from FCC 
channel center frequency.

To assist you in operating the 5 MHz band cor-
rectly within the rules specified by the FCC, 
transmission is impossible on any 5 MHz band 
frequency other than the 5 frequencies indicated in 
the table above.