ICOM 325300 Manual Do Utilizador
45
7
SCAN OPERATION
N Memory bank scan
IMPORTANT!: To perform memory bank scan, 2 or more
bank channels MUST be programmed, otherwise the scan
will not start.
bank channels MUST be programmed, otherwise the scan
will not start.
q Select memory bank mode.
± Select the memory mode with [V/M/C].
± Enter the memory bank selection mode with [BAND].
± Set a desired bank (A to Z) with [DIAL], then push
± Enter the memory bank selection mode with [BAND].
± Set a desired bank (A to Z) with [DIAL], then push
[BAND].
wSet the squelch level.
e Push and hold [SCAN](H/M/L) for 1 sec. to enter the scan-
ning type selection.
[DIAL]
All bank scan
Bank link scan
Bank scan
Duplex scan
Push and hold
for 1 sec.
for 1 sec.
Rotate
Selectable from “A” to “Z”
if programmed.
if programmed.
r Rotate [DIAL] to select a desired scanning type.
• “ALL” for all bank scan; “b-LInk” for bank link scan or “bAnk-
x
”
for bank scan (
x
= A to Z; programmed bank groups are only
displayed.), “dUP” (appears only when duplex operation is set)
for duplex scan.
for duplex scan.
tPush [SCAN](H/M/L) to start the scan.
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction. This also
• Rotate [DIAL] to change the scanning direction. This also
causes the transceiver to resume scanning.
• Push [V/M/C] to stop the scan.
• Push [BAND] to change the bank during bank scan.
• Push [BAND] to change the bank during bank scan.
During all bank/bank link scan
During bank scan
The bank-link setting can be changed in the Set mode.
See page 56 for details.
See page 56 for details.
Memory bank scan skips any memory channels in the se-
lected bank that are set to “SKIP” or “PSKIP.”
Memory bank scan stops at the first channel when all
channels in a bank are set to “SKIP” or “PSKIP.”
lected bank that are set to “SKIP” or “PSKIP.”
Memory bank scan stops at the first channel when all
channels in a bank are set to “SKIP” or “PSKIP.”