ICOM IC-M602 Manual Do Utilizador

■ Function display

q BUSY/TRANSMIT INDICATOR (p. 10)

➥“BUSY” appears when receiving a signal or when the

squelch opens.

➥“TX” appears while transmitting.

w RECEIVER ATTENUATOR INDICATOR (p. 10)

“LOCAL” appears when the receiver attenuator is in use.

e SCRAMBLER INDICATOR (p. 12)

“SCRAM” appears when an optional voice scrambler is ac-
tivated.

r SCAN INDICATOR

➥Either “NORMAL SCAN” or “PRI-SCAN 16” scan

type appears while scanning. (p. 15)

➥“DUAL 16” appears during dualwatch; “TRI 16”

appears during tri-watch. (p. 13)

tPOSITION INDICATOR
➥Shows the GPS position data.

• “??” may blink every 2 sec. instead of position data,

when the GPS position data is invalid. In such a case, the
last position data is held for up to 23.5 hours.

• “??” may blink every 2 sec. instead of position data, 4

hours after the position data is input manually up until
23.5 hours have past.

➥“No Position” appears when no GPS receiver is con-

nected and no position data is input manually.

y TIME ZONE INDICATOR

➥“Local” appears when the offset time data on the ‘Set

up’ menu is entered. (p. 34)

➥“No Time” appears when no GPS receiver is con-

nected and no time data is input manually.

u CHANNEL NAME INDICATOR

➥Channel comment appears if programmed. (p. 11)
➥“Low Batt” flashes when the battery voltage drops to

approx. 10 V DC or below.

BUSY

25W

---

INT

---

CALL

LOCAL

DUP

SCRAM

TAG

NORMAL

SCAN

34"34.506N

123"23.236W

Local

1:10

CALLING

PANEL DESCRIPTION