Supermicro CSE-733T-450/B Manual Do Utilizador
7
E.
Removing Components from or Installing
Devices into the 3.5" Drive Bays (SC733i only)
Devices into the 3.5" Drive Bays (SC733i only)
(For the SC733T chassis, you can access the hot swappable
3.5"
drives from the front side of the chassis without removing the side
cover. Please make sure to secure the drive tray with four screws
after you have installed components into it.)
Please follow the procedures listed below to remove the 3.5" drives in
order to install components into the drive bay (SC733i).
P r o c e d u r e
1. First, remove the side cover from the chassis so you can remove compo-
nents from or install devices into drive bays (refer to Section B).
2. Remove the three screws from the 3.5" drive brackets.
3. Pull the brackets toward the rear first and then pull them out from the
chassis.
4. Install the 3.5" drive into a bracket and secure it with screws.
5. Once you've installed the 3.5" drives into the brackets, place the backet
assembly with the drives into the chassis.
6. Secure the bracket with the three screws you removed earlier.
7. Slide the side cover back to position and secure it with screws.
Remove 3 screws
Four screws for each drive
(SC733i)
Removing Components or Installing Devices into the 3.5" Drive Bays