Innokas Yhtyma Oy VC150 Manual Do Utilizador
KO00065K
VC150 Vital Signs Monitor
B-5
Maintenance: Cleaning
Prohibited cleaning agents
Never use the following cleaning agents on the monitor, monitor accessories, or
the Exergen temporal scanner:
the Exergen temporal scanner:
•
Abrasive cleaners or solvents of any kind
•
Acetone
•
Ketone
•
Betadine
•
Alcohol-based cleaning agents. (However, an alcohol-based cleaning agent
can be used on the Welch Allyn temperature metal probe and plastic section
of the probe, Exergen scanner’s lens, probe head and metal neck only.)
can be used on the Welch Allyn temperature metal probe and plastic section
of the probe, Exergen scanner’s lens, probe head and metal neck only.)
•
Petroleum-based cleaning agents
•
Any type of solution that contains ammonium chloride, conductive
solutions, wax or wax compounds
solutions, wax or wax compounds
•
Sodium salts
NOTE
Never autoclave or steam clean the monitor, cuffs, or accessories.
Cleaning schedule
To prevent cross-contamination, clean exterior surfaces of the monitor, monitor
accessories, and reusable sensors on a regular basis in compliance with your
institution's infection control unit and/or biomedical department's local policy.
accessories, and reusable sensors on a regular basis in compliance with your
institution's infection control unit and/or biomedical department's local policy.
Procedure
WARNINGS
Always shut down the monitor and disconnect it from the electrical
network before any cleaning procedure.
network before any cleaning procedure.
Prior to using a cleaning agent, read the instructions for use and adhere
to provided safety precautions.
to provided safety precautions.
Never pour or spray water or any cleaning solution on the equipment or
permit fluids to run behind switches, into connectors, into the printer, or
into any ventilation openings in the equipment. Do not let fluid “pool”
around connection pins. Do not immerse the monitor, the sensors or the
hoses in liquids.
permit fluids to run behind switches, into connectors, into the printer, or
into any ventilation openings in the equipment. Do not let fluid “pool”
around connection pins. Do not immerse the monitor, the sensors or the
hoses in liquids.
Use of unapproved cleaning agents can cause case damage resulting
in unintended fluid ingress and a potential for compromising electrical
safety.
in unintended fluid ingress and a potential for compromising electrical
safety.
Do not use steam, heat, chemical or gas sterilization on the monitor or
its accessories. Do not autoclave the accessories.
its accessories. Do not autoclave the accessories.
NOTE
Clean the monitor and sensors according to local policies.