Security People Inc. dba Digilock 5GNMTRNLTR Manual Do Utilizador

 Touch RFID

Bolt Mechanism

Shared Use Functionality

Product Guide

Setup

Programming Instructions

R F I D

CARD

Manager

Locks are shipped with factory default settings (only operates by pressing 

`). Each lock must be setup to operate with a Programming 

Key and manager credentials (Manager Key or RFID).  

Insert the Programming Key.

A two-tone beep will be heard and 
the LED and Reader will turn on. 

Insert one Manager Key or present 
one Manager RFID at a time.

A two-tone beep will be heard for each 
manager credential programmed.

Insert the Programming Key.

A two-tone beep will be heard and 
the LED and Reader will turn off. 

Repeat above steps for each lock 
or follow instructions to Express 
Register Manager Credentials to 
setup all the locks.

Express Register Manager Credentials

The Programming Key can quickly program multiple locks to operate with the same manager credentials. 

Go to a lock already programmed to operate with the manager credentials.

Touch and hold 

` for 10 seconds (a two-tone beep will be heard after 

5 seconds followed by 2 sets of two-tone beeps after 10 seconds) then 
release. The LED will fl ash. 

Insert the Programming Key. 

Two sets of two-tone beeps will be heard and the LED will turn off. 

Insert the Programming Key to program each lock to operate with the same 
manager credentials.  

Two sets of two-tone beeps will be heard and the LED will fl ash once 
to indicate successful programming. 

End express registration mode.*

Go to any programmed lock.

Touch 

` then insert the Programming Key.

Touch 

` then insert the Programming Key again to return the bolt to the 

original position. 

*The Programming Key will continue to function in express registration mode until it is used to operate a lock.