Security People Inc. dba Digilock 5GNMTRNLTR Manual Do Utilizador

 Touch RFID

Bolt Mechanism

Shared Use Functionality

Product Guide

Programming Instructions

R F I D

CARD

Manager

Add Manager Credentials

Manager credentials can be programmed to the locks at any time. 

Go to a lock requiring additional 
manager credentials.

Touch and hold 

` for 5 seconds 

(a two-tone beep will be heard after 
5 seconds) then release. 

The LED will fl ash and the Reader 
will turn on. 

Insert the Programming Key. 

A two-tone beep will be heard. 

Insert each additional Manager Key 
or present each Manager RFID one 
at a time. 

A two-tone beep will be heard for each 
manager credential programmed. 

Insert the Programming Key. 

A two-tone beep will be heard and 
the LED and Reader will turn off. 

Repeat above steps for each lock 
or follow instructions to Express 
Register Manager Credentials to 
quickly program the same manager 
credentials to operate multiple locks. 

Replace Programming Key or Manager Credentials

The locks must be reprogrammed to prevent the lost/stolen Programming Key or manager credentials from operating a lock. 

Note the order or serial number (found on the lock’s rear unit). 

Contact Digilock Support to purchase a replacement Programming Key.

Collect all remaining and replacement manager credentials.

Go to any lock operated by the lost/stolen manager credentials.

Touch and hold 

` for 5 seconds (a two-tone beep will be heard after 5 

seconds) then release. 

The LED will fl ash and the Reader will turn on.

Insert the Programming Key.

A two-tone beep will be heard. 

Insert the Programming Key again. 

Three sets of two-tone beeps will be heard and the LED and Reader will 
turn off. All previously programmed manager credentials will be erased.

Follow instructions to Add Manager Credentials to program the remaining 
and replacement manager credentials to the locks.