Prentke Romich Company A-ACN100030PRC Manual Do Utilizador
Accent 1000 Hardware Manual
42
Storing Your Device
If you are not going to use the device for at least a month, store it in a dry place with moderate
temperatures (not too cold or too hot).
1. Charge the battery to 100%.
2. When the battery is fully charged, go to the Toolbox and select
1. Charge the battery to 100%.
2. When the battery is fully charged, go to the Toolbox and select
Maint Menu.
3. Open the
Battery Menu.
4. Select
Enter Ship Mode.
5. Respond
Yes to put your device into Ship Mode.
6. Select
OK to exit the Battery Menu.
7. Select
OK to exit the Maintenance Menu.
8.
Unplug the battery charger.
When you are ready to use your device again:
1. Plug in the battery charger.
2. Press the power button on your device. Your device will boot up. Leave the charger plugged in until
1. Plug in the battery charger.
2. Press the power button on your device. Your device will boot up. Leave the charger plugged in until
the battery is fully charged.
You can always check the status of the charge by looking at the bar graph next to the battery icon
in the status display area.
If the battery has gone completely dead: Plug in the battery charger. The charging LED on the front of
If the battery has gone completely dead: Plug in the battery charger. The charging LED on the front of
the device will begin to flash rapidly, indicating the battery is charging. Leave the battery charger
plugged in until the charging LED is only flashing about once a second which indicates the battery is fully
charged. For additional information, see “Battery Troubleshooting” on page 45.
Disposing of the Device or Battery
Device Disposal
Please dispose of your device in accordance with your local, state, and/or federal electronic recycling
laws.
Battery Disposal
If the battery in your device needs to be replaced, dispose of the old battery in accordance with your
local, state, and/or country regulations.