Extron Electronics EXTSL250W Manual Do Utilizador
ShareLink 250 W • Installation
3
Installation
This section covers the following:
•
•
•
•
Rear Panel Features and Cabling
The following section covers rear panel features and cabling procedures. If mounting is
necessary before connecting cables, see
necessary before connecting cables, see
B
B
ShareLink 250 W AUDIO
OUT
LAN / PoE
VGA OUT
HDMI OUT
USB 3
POWER
5V
2.3A MAX
Extron
ANT A
ANT B
2
USB
ShareLink 250 W
C
C
A
A B
B
C
C
D
D
E
E F
F
Figure 2.
Rear Panel
A
Audio output — (Optional) connect a 3.5 mm audio output cable between this female
audio jack and the audio input of a display or audio amplifier.
B
RJ-45 connector — Use an Ethernet cable to connect a network switch, hub, router,
or PC to this female RJ-45 connector.
NOTE: When the ShareLink 250 W is connected to a wired or wireless network, by
default it functions as a wireless access point, allowing access to the
ShareLink 250 W from all network computers. This feature can be disabled in the
WiFi Setup configuration settings (see
ShareLink 250 W from all network computers. This feature can be disabled in the
WiFi Setup configuration settings (see
,
1
, on page 42).
C
VGA output — (Optional) Connect a VGA display device or touchscreen into this
female VGA connector.
D
HDMI output — Connect an HDMI display device or touchscreen into this female
HDMI connector.
E
USB port — (Optional) Connect a USB flash drive to present documents, photos,
videos, or audio files using the ShareLink USB player feature (
,
5
on page 6).
F
Power input — Connect the included power supply to the power input (see the NOTE
and ATTENTION on the next page for important information).