ZyXEL SHDSL Router 791R 91-004-247008B Manual Do Utilizador

Prestige 791R G.SHDSL Router 

Step 1.  Launch the FTP client on your computer. 

Step 2.  Enter “open”, followed by a space and the IP address of your Prestige.   

Step 3.  Press [ENTER] when prompted for a username. 

Step 4.  Enter your password as requested (the default is “1234”). 

Step 5.  Enter “bin” to set transfer mode to binary. 

Step 6.  Use “put” to transfer files from the computer to the Prestige, for example, “put firmware.bin ras” 

transfers the firmware on your computer (firmware.bin) to the Prestige and renames it “ras”. 
Similarly, “put config.rom rom-0” transfers the configuration file on your computer 
(config.rom) to the Prestige and renames it “rom-0”. Likewise “get rom-0 config.rom” transfers 
the configuration file on the Prestige to your computer and renames it “config.rom.” See earlier 
in this chapter for more information on filename conventions. 

Step 7.  Enter “quit” to exit the ftp prompt. 

331 Enter PASS command 

Password: 

230 Logged in 
ftp> bin 

200 Type I OK 

ftp> put firmware.bin ras 

200 Port command okay 

150 Opening data connection for STOR ras 

226 File received OK 
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec. 

ftp> quit 

More commands (found in GUI-based FTP clients) are listed earlier in this chapter. 

Refer to section 15.2.5 to read about configurations that disallow TFTP and FTP over WAN. 

The Prestige also supports the uploading of firmware files using TFTP (Trivial File Transfer Protocol) over 
LAN. Although TFTP should work over WAN as well, it is not recommended. 

15-12 

  Firmware and Configuration File Maintenance