ZyXEL SHDSL Router 791R 91-004-247008B Manual Do Utilizador

 

 

Prestige 791R G.SHDSL Router 

Remote Node TCP/IP Configuration 

 

8-5 

Schedule Sets  This field is only applicable for PPPoE and PPPoA 

encapsulation. You can apply up to four schedule sets 
here. For more details please refer to the Call Schedule 
Setup chapter. 

Nailed up Connection  This field is only applicable for PPPoE and PPPoA 

encapsulation. This field specifies if you want to make 
the connection to this remote node a nailed-up 
connection.  More details are given earlier in this 
section. 

Session Options 

Edit Filter Sets 

Use [SPACE BAR] to choose Yes and press [ENTER] 
to open menu 11.5 to edit the filter sets. See the 
Remote Node Filter section for more details. 

No  

(default) 

Idle Timeout (sec)  Type the number of seconds (0-9999) that can elapse 

when the Prestige is idle (there is no traffic going to the 
remote node), before the Prestige automatically 
disconnects the remote node. 0 means that the session 
will not timeout. 

 

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to 
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen. 

You should employ the strongest authentication protocol possible. However, some vendor’s implementation 
includes specific authentication protocol in the user profile. It will disconnect if the negotiated protocol is 
different from that in the user profile, even when the negotiated protocol is stronger than specified. If the 
peer disconnects right after a successful authentication, make sure that you specify the correct 
authentication protocol when connecting to such an implementation. 

Perform the following steps to edit Menu 11.3 – Remote Node Network Layer Options as shown next. 

Step 1.  In menu 11.1, make sure IP is among the protocols in the Route field.