ZyXEL SHDSL Router 791R 91-004-247008B Manual Do Utilizador
Códigos do produto
91-004-247008B
Prestige 791R G.SHDSL Router
Remote Node TCP/IP Configuration
8-7
Table 8-2 Remote Node Network Layer Options
FIELD DESCRIPTION
EXAMPLE
NAT Press [SPACE BAR] and then [ENTER] to select Full Feature if you have
multiple public WAN IP addresses for your Prestige.
Select SUA Only if you have just one public WAN IP address for your
Prestige. The SMT uses Address Mapping Set 255 (menu 15.1 - see
section 11.3.1).
Prestige. The SMT uses Address Mapping Set 255 (menu 15.1 - see
section 11.3.1).
Select None to disable NAT.
SUA Only
Address
Mapping Set
When Full Feature is selected in the NAT field, configure address
mapping sets in menu 15.1. Select one of the NAT server sets (2-10) in
menu 15.2 (see the NAT chapter for details) and type that number here.
mapping sets in menu 15.1. Select one of the NAT server sets (2-10) in
menu 15.2 (see the NAT chapter for details) and type that number here.
When SUA Only is selected in the NAT field, the SMT uses NAT server
set 1 in menu 15.2 (see the NAT chapter for details).
set 1 in menu 15.2 (see the NAT chapter for details).
2
Metric The metric represents the “cost” of transmission for routing purposes. IP
routing uses hop count as the cost measurement, with a minimum of 1 for
directly connected networks. Type a number that approximates the cost
for this link. The number need not be precise, but it must be between 1
and 15. In practice, 2 or 3 is usually a good number.
directly connected networks. Type a number that approximates the cost
for this link. The number need not be precise, but it must be between 1
and 15. In practice, 2 or 3 is usually a good number.
2
Private This determines if the Prestige will include the route to this remote node in
its RIP broadcasts. If set to Yes, this route is kept private and not included
in RIP broadcast. If No, the route to this remote node will be propagated
to other hosts through RIP broadcasts.
in RIP broadcast. If No, the route to this remote node will be propagated
to other hosts through RIP broadcasts.
No
RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP Direction.
Options are Both, In Only, Out Only or None.
None
Version Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are RIP-1, RIP-2B or RIP-2M.
RIP-1
Multicast IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and
None disables IGMP.
None
IP Policies You can apply up to four IP Policy sets (from 12) by typing in their
numbers separated by commas. Configure the filter sets in menu 25 first
(see the IP Policy Routing chapter) and then apply them here.
(see the IP Policy Routing chapter) and then apply them here.
3, 4, 5, 6
Bridge Options
Ethernet Addr
Timeout (min)
Timeout (min)
See the chapter on Bridging Setup for information on bridging.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.