ZyXEL Prestige 660HW-D1 Wireless Router 91-004-593003B Manual Do Utilizador

P-660H/HW-D Series User’s Guide

Chapter 7 Wireless LAN

124

Figure 69   Start OTIST?

2 If an OTIST-enabled wireless client loses its wireless connection for more than ten 

seconds, it will search for an OTIST-enabled AP for up to one minute. (If you manually 
have the wireless client search for an OTIST-enabled AP, there is no timeout; click 
Cancel in the OTIST progress screen to stop the search.)

3 When the wireless client finds an OTIST-enabled AP, you must still click Start in the AP 

OTIST web configurator screen or hold in the RESET button (for one to five seconds) 
for the AP to transfer settings.

4 If you change the SSID or the keys on the AP after using OTIST, you need to run OTIST 

again or enter them manually in the wireless client(s).

5 If you configure OTIST to generate a WPA-PSK key, this key changes each time you run 

OTIST. Therefore, if a new wireless client joins your wireless network, you need to run 
OTIST on the AP and ALL wireless clients again.

The MAC filter screen allows you to configure the ZyXEL Device to give exclusive access to 
up to 32 devices (Allow) or exclude up to 32 devices from accessing the ZyXEL Device 
(Deny). Every Ethernet device has a unique MAC (Media Access Control) address. The MAC 
address is assigned at the factory and consists of six pairs of hexadecimal characters, for 
example, 00:A0:C5:00:00:02. You need to know the MAC address of the devices to configure 
this screen.

To change your ZyXEL Device’s MAC filter settings, click Network > Wireless LAN > 
MAC Filter. The screen appears as shown.