Vogel's PFW 6870 Video wall pop-out module 7368700 Folheto

PFW 6870 

Installation Instructions 

 

Page 11

This section presumes that you have read and 

understood thes 

Hardware" section.

1)  Place your flat-panel screen-side down on a soft, flat 

surface.

2)  Identify the number and location of the thread 

inserts on the back of your flat-panel.

3)  Aligning the holes on each mounting bracket with 

the thread inserts on the back of your flat-panel. 

4)  Secure each mounting bracket to your flat-panel by 

inserting a minimum of two (2) screws per bracket.

 Do not overtighten the mounting hardware.

Make sure the directional arrows on the mounting 

brackets are facing up.

         Mounting bracket adjustments are factory pre-set 

(see 

Note).

 This section requires two people.
 Do not release your flat-panel until you are certain 

that top and bottom hooks of both mounting 

brackets are securely seated on the upper and 

lower mounting rails of the wall panel.

1)  Raise the flat-panel past the top and bottom 

mounting rails on the wall panel.

2)  Slide the flat-panel down slowly, keeping it close to 

the wall.

3)  Engage the top and bottom mounting brackets to 

the rails of the mount.

Note: These registers 

must align prior to 

installation.They are 

factory set. Check 

to determine proper 

alignment