Ematic EMD212 Manual Do Utilizador

4

3

• When installing wall mounts on cinder block, verify that you have a minimum of 1-3/8”
  of actual concrete thickness in the hole to be used for the concrete anchors. Do not drill
  into mortar joints! Be sure to mount in a solid part of the block, generally 1” minimum
  from the side of the block. It is suggested 

 slow setting is used to drill the

  hole instead of a hammer drill to avoid breaking out the back of the hole when entering
  a void or cavity.

• Installer must verify that the supporting surface will safely support the combined load of
  the equipment and all attached hardware and components.

to use a

• Use the wall plate as a template to mark four holes locations on the wall as shown in fig.1.2.   
• Pre-drill these holes with an 8mm masonry bit to at least 50mm in depth. Insert a Concrete Anchor (P-B)

 

into 

  

each of these holes. Attach the wall plate to the wall using four screws (P-A), make sure that the wall plate is level 

  

as shown in fig.1.2.

 

fig.1.2

• Make sure that the supporting surface will safely support the combined load of the 
  equipment and all attached hardware and components.

• Tighten wood screws firmly, but do not over tighten. Over tightening can damage 
  the screws, greatly reducing their holding power.

• Make sure that mounting screws are anchored into the center of the studs. Use of 
  an “edge to edge” stud finder is highly recommended. 

• Hardware provided is for attachment of mount through standard thickness drywall
  or plaster into studs. Installers are responsible to provide hardware for other types 
  of mounting situations.

• 

Use a stud finder to locate the edges of the studs. Use of an edge-to-edge stud finder is highly recommended. 

   Based on their edges, draw a vertical line down each stud’s center. 

• 

Place wall plate on wall as a template. And mark the center of the four mounting holes. Make sure that the 

   mounting holes are on the stud centerline. 

• 

Drill four 1/8” (3mm) dia. Holes 1.2” (30mm) deep. Secure it using four screws (P-A), make sure that the wall 

   plate is level as shown in fig. 1.1.

fig.1.1

stud

 P-A

 P-A

 P-B