Ematic EMD212 用户手册
4
3
WARNING
• When installing wall mounts on cinder block, verify that you have a minimum of 1-3/8”
of actual concrete thickness in the hole to be used for the concrete anchors. Do not drill
into mortar joints! Be sure to mount in a solid part of the block, generally 1” minimum
from the side of the block. It is suggested
of actual concrete thickness in the hole to be used for the concrete anchors. Do not drill
into mortar joints! Be sure to mount in a solid part of the block, generally 1” minimum
from the side of the block. It is suggested
slow setting is used to drill the
hole instead of a hammer drill to avoid breaking out the back of the hole when entering
a void or cavity.
a void or cavity.
• Installer must verify that the supporting surface will safely support the combined load of
the equipment and all attached hardware and components.
the equipment and all attached hardware and components.
to use a
1b
SOLID BRICK AND CONCRETE BLOCK MOUNTING:
• Use the wall plate as a template to mark four holes locations on the wall as shown in fig.1.2.
• Pre-drill these holes with an 8mm masonry bit to at least 50mm in depth. Insert a Concrete Anchor (P-B)
• Pre-drill these holes with an 8mm masonry bit to at least 50mm in depth. Insert a Concrete Anchor (P-B)
into
each of these holes. Attach the wall plate to the wall using four screws (P-A), make sure that the wall plate is level
as shown in fig.1.2.
fig.1.2
WOOD STUD WALL MOUNTING:
1a
WARNING
• Make sure that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.
equipment and all attached hardware and components.
• Tighten wood screws firmly, but do not over tighten. Over tightening can damage
the screws, greatly reducing their holding power.
the screws, greatly reducing their holding power.
• Make sure that mounting screws are anchored into the center of the studs. Use of
an “edge to edge” stud finder is highly recommended.
an “edge to edge” stud finder is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall
or plaster into studs. Installers are responsible to provide hardware for other types
of mounting situations.
or plaster into studs. Installers are responsible to provide hardware for other types
of mounting situations.
•
Use a stud finder to locate the edges of the studs. Use of an edge-to-edge stud finder is highly recommended.
Based on their edges, draw a vertical line down each stud’s center.
•
Place wall plate on wall as a template. And mark the center of the four mounting holes. Make sure that the
mounting holes are on the stud centerline.
•
Drill four 1/8” (3mm) dia. Holes 1.2” (30mm) deep. Secure it using four screws (P-A), make sure that the wall
plate is level as shown in fig. 1.1.
fig.1.1
stud
P-A
P-A
P-B