Symantec Backup Exec System Recovery Windows Small Business Server Edition 11859262 Manual Do Utilizador
Códigos do produto
11859262
Restoration of a DHCP server
You cannot restore a DHCP server from a recovery point that is stored on the
network. The recovery environment must get an IP address from the DHCP server.
If the computer you are restoring is the DHCP server from which the recovery
environment is trying to get a dynamic IP address, the task will be unsuccessful.
network. The recovery environment must get an IP address from the DHCP server.
If the computer you are restoring is the DHCP server from which the recovery
environment is trying to get a dynamic IP address, the task will be unsuccessful.
Specify a static IP address manually.
Setting the time zone and then exiting the recovery environment
When you set the time zone in the main window of the recovery environment, be
sure that you exit the recovery environment properly by clicking Exit in the main
window as well. This ensures that the computer's CMOS clock remains unchanged
(or is reset to its original time). Do not exit the recovery environment by pressing
the computer's restart button.
sure that you exit the recovery environment properly by clicking Exit in the main
window as well. This ensures that the computer's CMOS clock remains unchanged
(or is reset to its original time). Do not exit the recovery environment by pressing
the computer's restart button.
Using a SAN
If you use a SAN without a local disk drive and the operating system and the data
partitions run from the SAN over Emulex fibre channel cards, you might not be
able to restore an entire recovery point. You can, however, use the Recovery Point
Browser to restore individual files from the recovery point.
partitions run from the SAN over Emulex fibre channel cards, you might not be
able to restore an entire recovery point. You can, however, use the Recovery Point
Browser to restore individual files from the recovery point.
Using dual-ported fibre channel cards
If you use dual-ported fibre channel cards that are connected for redundancy, you
should disconnect one channel before you attempt to restore a recovery point by
using Symantec Recovery Disk.
should disconnect one channel before you attempt to restore a recovery point by
using Symantec Recovery Disk.
Wireless devices
The Symantec recovery environment does not support wireless devices. If you
need to recover files, folders, or your computer from recovery points that you
normally access from Windows over a wireless network, you must connect the
storage device that contains your recovery points directly to your computer using
either a network or USB cable.
need to recover files, folders, or your computer from recovery points that you
normally access from Windows over a wireless network, you must connect the
storage device that contains your recovery points directly to your computer using
either a network or USB cable.
Viewing your IP address or other configuration information
You can view your IP address or any other configuration information from the
recovery environment.
recovery environment.
Troubleshooting Backup Exec System Recovery
Troubleshooting the recovery environment
Troubleshooting the recovery environment
200