Hirose Electronic HR30-6P-6P(71) Ficha De Dados

Solder termination fixture

Insulator/contact assembly

Block end face

10

B

Plug Assembly Sequence

1

2

Thread the back shell, strain relief, seal bushing, spring and push/pull locking collar over the cable as shown above.

Solder type

1. Pre-solder the exposed cable conductors (dia. A). The diameter of the pre-soldered conductors should not exceed 0.7

mm for 6 contact plug and 1.0 mm for 3 contact plug.

2. Insert the insulator body over the applicable solder termination fixture.

3. Insert the pre-soldered conductors in the contact soldering pot and solder them in place.

Soldering iron temperature should be 

280 ±10ç

applied for 3-4 second.

Crimp type

1. Crimp the applicable contact to the stripped conductor. Use correct crimp tools. Verify the dimensions and crimp

configuration.

2. Insert the contact into the appropriate opening in the insulator body.

3. Verify fully seated position by applying a slight pull force on the conductor. The contact should remain in place. 

Re-insert if not seated.

A

B

Solder type : 3 and 6 pos.

Solder type : 12 pos.

Crimp type : 10 and 12 pos.

2 mm

2 mm 

2

mm

-

0

-0.5

5.5 mm max. 

10 mm max. 

15

to 

20 mm

B

Seal bushing

Strain relief

Back shell 

Insulator/contact assembly

Cable

Spring 

Push/pull locking collar

A

The product  information in this catalog is for reference only. Please request the  Engineering Drawing for the most current and accurate design  information.

All non-RoHS products  have been discontinued, or will be discontinued soon. Please check the  products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your  Hirose sales representative.