Hirose Electronic HR30-6P-6P(71) Ficha De Dados

Push/pull
locking collar

Guide keys

Cable

Solder termination fixture

Tightening collar for back shell

Cable

Back shell

Plug insulator body

View A (2:1)

Front edge of cable jacket

Figure B

Figure C

Groove - sealing bushing

1. To prevent accidental loosening of the back shell it is recommended that a small amount of primer (Loctite® 7649) and

adhesive (Loctite® 271) be applied to the threads of the insulator body before proceeding.

2. Keeping the terminated insulator body on the fixture, re-assembly the plug in order shown.

4. Using the correct back-tightening collar tighten the back shell to the specified torque.

When tightening the collar make sure that the cable will NOT turn.

5. Remove the assembly from the fixture.

Back shell tightening collar size

Torque

3 and 6 Pos.

10 and 12 Pos.

16 mm

18 mm

0.5N.m

Connector

Note: Loctite is a registered trademark of the Henkel Loctite Corporation.

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.