Steinberg UR22 AUDIO-INTERFACE 502004313 Ficha De Dados
Códigos do produto
502004313
UR22
Operation Manual
11
Configuring Audio Driver
Settings on the DAW Software
Settings on the DAW Software
Cubase series Programs
1.
Make sure that all applications have been
quit.
quit.
2.
Connect the device directly to the computer
by using the included USB cable.
by using the included USB cable.
NOTE
・(Windows only) Make sure to use the same USB
port as the one used in the installation procedure
when you connect the UR22 to the computer again.
If you connect it to a different USB port, you will
have to install the driver again.
when you connect the UR22 to the computer again.
If you connect it to a different USB port, you will
have to install the driver again.
3.
Double-click the shortcut of Cubase series
on the desktop to start Cubase.
on the desktop to start Cubase.
4.
When the “ASIO Driver Setup” window
appears while the Cubase series program is
launching, confirm that the device is
selected, then click “OK.”
appears while the Cubase series program is
launching, confirm that the device is
selected, then click “OK.”
The audio driver settings are now complete.
Programs Other Than Cubase
Series
Series
1.
Make sure that all applications have been
closed.
closed.
2.
Connect the device directly to the computer
by using the included USB cable.
by using the included USB cable.
NOTE
・Make sure that only one device compatible with
Yamaha Steinberg USB Driver is connected.
・(Windows only) Make sure to use the same USB
port as the one used in the installation procedure
when you connect the UR22 to the computer again.
If you connect it to a different USB port, you will
have to install the driver again.
when you connect the UR22 to the computer again.
If you connect it to a different USB port, you will
have to install the driver again.
3.
Launch the DAW software.
4.
Open the audio interface settings windows.
5.
(Windows only) Select the “ASIO Driver” for
the audio driver settings.
the audio driver settings.
6.
Set as follows.
Windows
Set the Yamaha Steinberg USB ASIO for the
ASIO Driver settings.
ASIO Driver settings.
Mac
Set the UR22 for the audio interface settings.
The audio driver settings are now complete.
Recording/Playback
Cubase Series Programs
1.
Launch the Cubase series DAW.
The “Project Assistant” window appears.
2.
Select the desired project template in
“Recording” on the “Project Assistant”
window, then click “Create.”
“Recording” on the “Project Assistant”
window, then click “Create.”
3.
When the “Missing Ports” window appears,
select the UR22 port for each of the
“Mapped Ports.” Enter checkmarks to the
corresponding “Map Always” boxes, then
click “OK.”
select the UR22 port for each of the
“Mapped Ports.” Enter checkmarks to the
corresponding “Map Always” boxes, then
click “OK.”
NOTE
・If you enter a checkmark for “Map Always,” the
“Missing Ports” window will not appear from the next
time.
time.
4.
Set the [MIX] knob to the center position
between [INPUT] and [DAW].
between [INPUT] and [DAW].
5.
While singing into the microphone, adjust
the input signal level of the microphone by
the [INPUT GAIN] knob on the device.
the input signal level of the microphone by
the [INPUT GAIN] knob on the device.
To achieve optimum recording levels, increase
the input level with the [INPUT GAIN] knob until
the [PEAK] indicator lights in red, then slowly
bring the level down until it stops lighting in
red.
the input level with the [INPUT GAIN] knob until
the [PEAK] indicator lights in red, then slowly
bring the level down until it stops lighting in
red.