Rc Logger System-sensor 20002RC Manual Do Utilizador
Códigos do produto
20002RC
Power ﹠ RPM module
No. 20002RC
Version 07/11
Dear Customer,
The POWER OUT must be connected to the ESC before connecting the battery
to the POWER IN! The system will be damaged if the connection priority is
wrong! Refer to the illustration attached.
Always follow the steps of the operating instructions. Incorrect order of the steps can cause
>
malfunctions of all other connected electronic parts.
Unless otherwise specified, turn off the RC Logger HD, PRO or LC before any connection
>
Before start-up, make sure that the RPM cable is connected to the port with the label “RPM”
>
(see operating instructions, operating element no. 10).
On no account connect the RPM cable to the port labeled “Buzzer”, as this can cause
>
malfunctions of the connected modules downstream.
Your RC Logger team
This information is published by CEI Conrad Electronic International (HK) Limited,
28th Floor & 2903-9, Pacific Plaza, 418 Des Voeux Road West, Hong Kong.
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the
capture in electronic data processing systems require the prior written approval by the editor. Reprinting, also
in part, is prohibited.
The information reflects the current technical specifications at time of print. We reserve the right to change the
technical or physical specifications.
© 2011 by CEI Conrad Electronic International (HK) Limited
© 2011 by CEI Conrad Electronic International (HK) Limited
V2_0711-HL
Módulo de potencia y RPM
Nº 20002RC
Versión 07/11
Estimado cliente,
¡POWER OUT se debe conectar a ESC antes de conectar la batería a POWER IN!
Si la secuencia de la conexión es incorrecta, se dañará el sistema. Consulte la
ilustración adjunta al presente.
Aténgase siempre a los pasos de las instrucciones de manejo. Un orden incorrecto de los
>
mismos puede causar un mal funcionamiento de las partes electrónicas conectadas.
A menos que se especifique lo contrario, apague el RC Logger HD, PRO o LC antes de
>
realizar cualquier conexión.
Antes de la puesta en funcionamiento, asegúrese de que el cable de revoluciones se
>
encuentra conectado al puerto identificado con la denominación “RPM” (véase el manual de
instrucciones, dispositivo de control Nº 10).
Asegúrese de no conectar nunca el cable de revoluciones al puerto identificado con la
>
denominación “Buzzer”, dado que esto podría ocasionar el mal funcionamiento de la cadena
del módulo conectado.
Su equipo RC Logger
Esta información es una publicación de CEI Conrad Electronic International (HK) Limited,
28th Floor & 2903-9, Pacific Plaza, 418 Des Voeux Road West, Hong Kong.
Se reservan todos los derechos, incluidos los de traducción. Las reproducciones de cualquier tipo, por ejemplo
fotocopias, microfilmación o almacenamiento en aparatos de procesamiento de datos electrónicos, requieren
una autorización por escrito del fabricante. Está prohibida la reimpresión, incluida la reimpresión de pasajes.
Esta información se corresponde al estado de la tecnología en el momento en que entraron en imprenta. Se
reservan los derechos de realizar modificaciones de la tecnología y del diseño.
© 2011 by CEI Conrad Electronic International (HK) Limited
© 2011 by CEI Conrad Electronic International (HK) Limited
V2_0711-HL