Proma 140001 UV Exposure Unit with Vacuum, 135W 140001 Ficha De Dados

1.

Connect the unit to 230 V mains.

2.

Open the cover and activate the mains switch.

A buzzing of the vacuum pump must be had hear. Within approx. 30 seconds, a low air

pressure of approx. 

 bar must have built up (the film below the pressure screw is

sucked onto the edition pane).

Do not block the hole in the support pane if the pump is activated. It would be able to

shatter due to low air pressure.

 Do not remove or damage the film under the hinged pane.

 Press easily the support pane against the sponge rubber frame if no low air pressure is

built up; possibly, check the horizontal placement of the device (especially important in the

case of the device types 3 and 4).

 During film exposure with the double-sided exposure device, we recommend to cover the

support pane using an opaque base (e. g. pasteboard) since also with a switched-off

lower exposure box light is reflected from the bottom.

With the built-in timer, you can adjust the lighting duration of the UV tube. Time setting is

possible in seconds or minutes.

Minutes-/seconds

\

 display points

\

\

       

This point lights up if

the cover is opened.

These points only light up in the

‘Minute timer‘ operating mode

Rotating knob and push-button combination

for setting the operating mode and the time

and the  Start/Stop key