Zircon ElectriScanner V5 Metal and Live Wire Detector 64223 64223 Manual Do Utilizador
Códigos do produto
64223
When turned on, the tool runs a battery test .
If the battery has adequate voltage, the READY light will turn green and either
If the battery has adequate voltage, the READY light will turn green and either
the AUTO or MANUAL mode indicator will light up amber (depending on which
mode the unit was last in) . The tool is ready to begin scanning .
If the battery is weak, but operable, the READY light will quickly and
If the battery is weak, but operable, the READY light will quickly and
continuously flash orange . The tool is usable, but the battery may need to be
replaced soon .
If the battery is almost dead, the READY light will slowly pulse red . The tool
If the battery is almost dead, the READY light will slowly pulse red . The tool
cannot be used in this state and a fresh battery should be inserted .
If the battery is completely dead, the tool will not turn on at all .
The battery level will be continually monitored as long as the unit is operational .
If the battery is completely dead, the tool will not turn on at all .
The battery level will be continually monitored as long as the unit is operational .
3. tHE tWO MODES
The ElectriScanner
™
v5 live wire locator offers two scanning modes to enable users to achieve
the most accurate scanning results given the wide variety of scanning conditions .
AUTO Mode: This mode is also termed the “smart” mode because it constantly monitors the
AUTO Mode: This mode is also termed the “smart” mode because it constantly monitors the
environment during scanning and “learns” the wall when in this mode . If it detects a strong
electrical signal, it will disregard weaker signals in order to home in on the strongest, most
prominent signal in the area .
Walls, floors, and ceilings can contain several objects that can either carry or hold a small
Walls, floors, and ceilings can contain several objects that can either carry or hold a small
electrical charge . Electrical fields emitted by live wires can cling to studs or pipes, giving the
impression of a very low-voltage wire . The AUTO mode will display weak electrical signals as
a live wire if it does not scan over a stronger signal . If the tool detects a stronger signal, like
unshielded standard wire, it will disregard weaker signals and direct you to the live wire .
AUTO mode works best in most scanning situations . If you are having problems finding the wire
AUTO mode works best in most scanning situations . If you are having problems finding the wire
in AUTO mode, switch to MANUAL mode .
MANUAL Mode: The tool reports all results and, unlike AUTO mode, will not disregard weaker
MANUAL Mode: The tool reports all results and, unlike AUTO mode, will not disregard weaker
signals . The tool will indicate the direction of the strongest signal nearby at any given time, even
if it has encountered stronger signals before .
MANUAL mode is best used when scanning in difficult environments, when you need to locate
MANUAL mode is best used when scanning in difficult environments, when you need to locate
more than one wire, or if you are searching for a lower voltage wire in the vicinity of higher
voltage ones .
4. tOGGLING BEtWEEN MODES
To toggle between AUTO and MANUAL modes,
release the Power button and quickly press
it back down again, holding it in . The mode
indicator lights will display the current mode .
When you turn the tool on, it will start up in
the last mode it was left in .
4 EN