Insys GSM Small 11-02-01-03-02.001 Manual Do Utilizador
Códigos do produto
11-02-01-03-02.001
6. Function Description
27
6 Function Description
6.1 Data
Connection
6.1.1 General
ATD22243
Dial number to which a connection is to be set up (always
with dialing code, except for special provider numbers).
with dialing code, except for special provider numbers).
CONNECT 9600/RLP
The call is accepted. The data is exchanged over the GSM
network.
network.
+++
Changing from data mode to online AT command mode.
Before and after this “Escape sequence”, there must be one
second message “Silent” on the TXD line to the INSYS GSM
small.
The connection still remains, but no characters are
transmitted to the other modem anymore.
Before and after this “Escape sequence”, there must be one
second message “Silent” on the TXD line to the INSYS GSM
small.
The connection still remains, but no characters are
transmitted to the other modem anymore.
ATH
Hang up (terminate connection to the other party)
or
ATO
ATO
Return to data mode
NO CARRIER
The other party has terminated the connection
6.1.2 Connection to ISDN TAs
To call an ISDN TA it is necessary to change to the ISDN protocol V.110. While doing so it
must be observed that the remote terminal has to work with the same protocol as well.
Example for V.110 with a data rate of 9600 bps: AT+CBST=71,0,1
must be observed that the remote terminal has to work with the same protocol as well.
Example for V.110 with a data rate of 9600 bps: AT+CBST=71,0,1
6.1.3 Connection Acceptance
The connection acceptance for incoming calls takes place either automatically with
ATS0=x
ATS0=x
or manually by entering ATA after a RING.
6.1.4 Disconnection
Connections can be terminated as follows:
• Manually by the ATH command in online command mode
• If the remote terminal hangs up
• By DTR drop
• If the remote terminal hangs up
• By DTR drop
Version 1.00 / 09.04