Mc Crypt UHF-2032 Wirless Microphone Set 304919 Ficha De Dados

4 transmitting channels can be set for each microphone. The channel settings at the microphones and
at the receiver must be identical.

• Switch off the microphone (push switch downwards).

• Screw off the casing bottom of the microphone

• Set the transmission channel at microphone A to the desired channel (0-3) with the DIP switches.

• Set the same channel at the receiver with the buttons ST (4). The channel or the frequency is displayed in the

left part of the display (5).

• The display at the receiver can be switched with the CH/FREQ (3) button between the frequency display and the

channel display.

• Set the transmission channel at microphone B and the receiver channel B at the receiver as described as well.

The buttons ST (6) at the receiver are responsible for switching on the microphone channel B.

• Switch on the receiver by pressing the POWER switch (2). The display (5) lights up.

• Switch on the microphones by pushing the microphone switch upwards in the direction of the microphone head

grille. The operating displays at the microphones light up.

• In the display (5) of the receiver, the signal strength RF and the audio signal AF strength for the microphones A

and B is displayed.

• Set the desired volume with the VOL A (7) and VOL B (8) controls at the receiver and the volume control on the

audio device.

Where there is any interfering noise or problems due to the range, try several channel settings at the
microphones and receiver. The settings at the microphone and the receiver receiver channel, however,
must always be identical. Otherwise, there will be no radio transmission.

Alternatively, you may also try realigning the aerials for better reception.