Linear Technology LTC2263-14 14-Bit, 25Msps, 1.8V Dual Serial ADC, 5MHz DC1532A-F Ficha De Dados
Códigos do produto
DC1532A-F
5
dc1532f
DEMO MANUAL DC1532
Serial Programming
PScope has the ability to program the DC1532 board
PScope has the ability to program the DC1532 board
serially through the DC1371. There are several options
available in the LTC2268 family that are only available
through serially programming. PScope allows all of these
features to be tested.
These options are available by first clicking on the Set
These options are available by first clicking on the Set
Demo Board Options icon on the PScope toolbar (Figure 3).
Quick start proceDure
Figure 3. PScope Toolbar
Figure 4: Demo Board Configuration Options
This menu allows any of the options available for the
LTC2268 family to be programmed serially. The LTC2268
family has the following options:
Randomizer: Enables Data Output Randomizer
• Off (Default): Disables data output randomizer
• On: Enables data output randomizer
Two’s complement: Enables two’s complement mode
• Off (Default): Selects offset binary mode
• On: Selects two’s complement mode
Sleep Mode: Selects between normal operation, sleep mode
• Off (Default): Entire ADC is powered, and active
• On: The entire ADC is powered down
Channel 1 Nap: Selects between normal operation and
Randomizer: Enables Data Output Randomizer
• Off (Default): Disables data output randomizer
• On: Enables data output randomizer
Two’s complement: Enables two’s complement mode
• Off (Default): Selects offset binary mode
• On: Selects two’s complement mode
Sleep Mode: Selects between normal operation, sleep mode
• Off (Default): Entire ADC is powered, and active
• On: The entire ADC is powered down
Channel 1 Nap: Selects between normal operation and
putting channel 1 in nap mode
• Off (Default): Channel one is active
• On: Channel one is in nap mode
Channel 2 Nap: Selects between normal operation and
• Off (Default): Channel one is active
• On: Channel one is in nap mode
Channel 2 Nap: Selects between normal operation and
putting channel 2 in nap mode
• Off (Default): Channel two is active
• On: Channel two is in nap mode
Output Current: Selects the LVDS output drive current
• 1.75mA (Default): LVDS output driver current
• 2.1mA: LVDS output driver current
• 2.5mA: LVDS output driver current
• 3.0mA: LVDS output driver current
• 3.5mA: LVDS output driver current
• 4.0mA: LVDS output driver current
• 4.5mA: LVDS output driver current
• Off (Default): Channel two is active
• On: Channel two is in nap mode
Output Current: Selects the LVDS output drive current
• 1.75mA (Default): LVDS output driver current
• 2.1mA: LVDS output driver current
• 2.5mA: LVDS output driver current
• 3.0mA: LVDS output driver current
• 3.5mA: LVDS output driver current
• 4.0mA: LVDS output driver current
• 4.5mA: LVDS output driver current
This will bring up the menu shown in Figure 4.