Mikroelektronika MikroE Development Kits MIKROE-1424 Ficha De Dados

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS™ socket. Make sure to align the 
cut in the lower-right part of the board 
with the markings on the silkscreen at the 
mikroBUS™ socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. Place 
shorter parts of the header pins in both 
soldering pad locations.

Before using your click board™, make sure 
to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

Light click Manual

0 100000 023761

Light Click

™

 is an accessory board in 

™

 form factor. It’s a compact 

and easy solution for adding light sensor 
to your design. It features 

 PIN photodiode, 

 voltage 

reference and 

 ADC with SPI 

interface. Light Click

™

 communicates 

with the target board microcontroller via 

™ 

SPI (MISO, SCK, CS) and AN 

lines. The board is designed to use 3.3V 
and 5V power supply. LED diode (GREEN) 
indicates the presence of power supply.

Light 

click

Light Click™ with it’s 

 and 

 ICs is a high photosensitive 

light sensor with fast response time. The 
board is capable of measuring ambient light 
intensity and provides a signal (analog or 
digital) to the main board microcontroller. 
All these features make this board ideal for 
high speed photo detector, copier, game 
machine and many more.