ONKYO T-4030 40030B Ficha De Dados

En-

16

■ Selecting Presets

To select a preset, use the number buttons on 
the remote controller, the remote controller’s 
arrow [A]/[S] buttons or the tuner’s PRESET 
[a]/[s] buttons.

■ Deleting Presets

Select the preset that you want to delete.
See the previous section.

While holding down the [MEMORY] button, 
press the [TUNING MODE] button.
The preset is deleted and its number disappears 
from the display.

■ Presetting Automatically

Press and hold the [AUTO SCAN] button for 
3 seconds to start Auto Tuning function.
Up to 40 stations can be preset and presets are 
stored in frequency order.

Note:
Depending on your location, a preset may be stored with 

no station and you will hear only noise when you select 

it. In this case, delete the preset.

■ Name Edit

You can enter a custom name for radio preset for easy 

identification. When entered, the custom name will 

appear on the display.
The custom name is edited using the character input 

screen.

Use the arrow [D]/[F] button to select 
“Name Edit,” and then press [ENTER].

Use the arrow [D]/[F]/[A]/[S] button to 
select a character, and then press [ENTER]. 
Repeat this step to enter up to 8 characters.

When you’ve finished editing the name and 
want to store it, be sure to use the arrow 
[D]/[F]/[A]/[S] button to select “OK” and 
then press [ENTER]. If you fail to do this, 
the name won’t be saved.

• Characters are categorized into two groups: character 

set 1 primarily for lower case letters, and character set 

2 primarily for upper case letters. 

You can select characters in each character set by 

pressing the [D]/[F] buttons. 

Press the [A]/[S] buttons to select a character to input, 

and then press the [ENTER] button to confirm. 

If you do not find a character that you want to select in 

the currently-displayed character set, press the [D]/

[F] buttons to display string “Shift I J BS OK”, use 

the [A]/[S] buttons to select “Shift”, and then press 

the [ENTER] button to display the other character set.

• The following table shows available characters. 

The meaning of commands other than alphabetical 

characters, numbers and symbols is as follows:

Enters a space character.

Switches the displayed character.

I(Left)/J(Right):

Select these to move the cursor within the Name 
input area.

Deletes the character to the left of the cursor.

Specifies that the entry is complete.

Tips:
* You can also perform this on the remote 

controller by using [D.TUN].