Invacare Non-Removable Device 1820 Manual Do Utilizador

Part No 1076733

Non-Removable Device

For more information regarding Invacare products, parts, and services,

please visit www.invacare.com

Non-Removable Device

Model No. 1820

NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact
Carrier/Invacare for further instructions.

Safety Summary

To ensure the safe installation of the non-removable device, these instructions
MUST be followed:

WARNING

DO NOT install this equipment without first reading and understanding this

instruction sheet. If you are unable to understand the warnings, cautions and

instructions, contact a healthcare professional, dealer or technical personnel

if applicable, before attempting to install this equipment - otherwise, injury or

damage may occur.
Invacare products are specifically designed and manufactured for use in

conjunction with Invacare accessories. Accessories designed by other

manufacturers have not been tested by Invacare and are not recommended

for use with Invacare products.
After ANY adjustments, repair or service and BEFORE use, make sure that

all attaching component parts are secure.

Installing Non-Removable Device

NOTE: For this procedure, refer to FIGURE 1 on page 3.

1. Install front rigging onto the wheelchair.

CAUTION

It may be necessary to widen the opening of the clamp to prevent scratching

the wheelchair frame.

NOTE: There is a right clamp and a left clamp. Ensure that the clamp tab is at the bottom
of the clamp before installing.

2. Follow one of the following instructions:

• Footrest - Position the clamp between the two hinge plates of the footrest

(Detail “A”).

• Elevating Legrest - Position the clamp above the upper hinge plate of the

elevating legrest (Detail “B”).

Assembly, Installation and Operating Instructions

SAVE THESE INSTRUCTIONS